[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Removal steps
1.Roof drip molding cover A
2.Roof drip molding cover B
3.Roof drip molding front
4.Roof drip molding center
5.Roof drip molding rear
>>A<<6.Roof drip molding clip (front)
>>A<<7.Roof drip molding clip (rear)
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< ROOF DRIP MOLDING CLIP INSTALLATION
Apply the specified sealant to the roof drip molding clip surface, and install the roof drip molding clip.
Specified adhesive: 3M™-DP-8010, 3M™-DP-8005 or equivalent
 
 
 
1. Remove any remnants of the old tape. Then degrease the adhesion surface by using a cloth moistened with 3M™ AAD Part number 8906 or equivalent.
2. Apply the specified adhesive to the adhesion surface of the roof molding clip.
Specified adhesive: 3M™-DP-8010, 3M™-DP-8005 or equivalent
3. Adhere the roof drip molding clip as shown.
4. Wait for at least 10 minutes. Then install the roof drip molding.