23C-ABNORMAL SOUND OCCURS DURING GEAR SHIFT.

Inspection Procedure 14: Abnormal sound occurs during gear shift.

PROBABLE CAUSES

Abnormal incoming route of sound: Installation of transaxle control cable, damping device, sound isolation device
A/T failure: Driving force transaxle system (gear), hydraulic system (valve body assembly, hydraulic circuit)

note

Inspection items for abnormal sound

Check of sound source and incoming route (radiated sound, propagation sound, resonance, etc.), and measurement at driver's seat, front passenger's seat, and rear passenger's seat
Change of sound during cold and after warm up (Change of fluid, and hydraulic pressure)
Change of sound with the throttle valve opening (engine output change, hydraulic pressure change)
Change of sound on a flat road, upslope, and downslope
Check of tone

DIAGNOSIS

STEP 1. Check the installation of the transaxle control cable, damping device, and sound isolation device.

Is the check result normal?

Go to Step 2

Repair the failure, and perform adjustment.

STEP 2. Compare with another same model vehicle.

Is there a difference from the same model vehicle?

Go to Step 3

The procedure is complete.

STEP 3. Remove the transaxle assembly from the vehicle.

Disassemble and check the transaxle assembly to check if there is a foreign material inside.

Is the check result satisfactory?

Replace the transaxle assembly.

Replace the failure part.