Inspection Procedure 3: The vehicle does not run at the "D" or the "R" range.
PROBABLE CAUSES
Poor adjustment of transaxle control cable
A/T failure: Hydraulic system (valve body assembly), driving force transaxle system (clutch/brake)
DIAGNOSIS
STEP 1. Check the transaxle control cable.
Check the installation status of transaxle control cable and transmission range switch.
Is the check result normal?
Go to Step 2
.
Adjust the installation status of transaxle control cable and transmission range switch. (Refer to
.)
STEP 2. Check the transmission fluid.
Check the transmission fluid for seizure, fouling, and level.
Is the check result normal?
The procedure is complete.
Go to Step 3
.
STEP 3. Remove the transaxle assembly from the vehicle.
Disassemble and check the transaxle assembly to check if there is a foreign material inside.
Is the check result satisfactory?
Replace the transaxle assembly.
Replace the failure part.
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
Go to Step 2
.
Adjust the installation status of transaxle control cable and transmission range switch. (Refer to .)The procedure is complete.Go to Step 3.Replace the transaxle assembly.Replace the failure part.