LINE PRESSURE ADJUSTMENT 1.Drain the transmission fluid. NOTE: The hydraulic pressure test must be performed before attempting any adjustments. 2.Remove the valve body cover.

3.Turn the adjusting screw shown in the illustration to adjust the line pressure to the standard value. The pressure increases when the screw is turned counterclockwise. NOTE: Adjust to the middle of the standard range when the transmission is at the 1st or 2nd gear. Standard value: 0.98 - 1.05 MPa (142 - 152 psi) NOTE: Each complete turn of the adjusting screw changes pressure: 0.035 MPa (5.1 psi) 4.Install the valve body cover. Pour in one quart transmission fluid. 5.Repeat the hydraulic pressure test. (Refer to .) Readjust the line pressure if necessary.