[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Removal Steps
1.Harness cover <Vehicles without FCM/LDW/AHB-ECU (From 22 Model year)>
2.Connector
<<A>>>>B<<3.Lighting control sensor
>>A<<4.Silicone pad
 
 
REMOVAL SERVICE POINT
 
 
<<A>> LIGHTING CONTROL SENSOR REMOVAL
caution
  • Do not touch the light-sensing part on the lighting control sensor. Make sure that no foreign materials are adhered.
  • Remove the silicon pad if it remains on the glass. Make sure that no foreign materials are adhered.
Pull out the stopper of the lighting control sensor to remove it.
 
 
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< SILICONE PAD INSTALLATION
Attach the silicone pad to the lighting control sensor as shown.
 
 
 
>>B<< LIGHTING CONTROL SENSOR INSTALLATION
cautionMake sure that no silicon pad remains on the glass.
1. Keep the stopper of the lighting control sensor pulled out.

2. Push the silicon pad, which is attached on the light-sensing part of the lighting control sensor, onto the glass to secure the sensor to the bracket.
noteTo install the new lighting control sensor to the sensor bracket, pull out the stopper, and peel off the protection sheet.
3. Insert the stopper of the lighting control sensor, and make that the sensor is installed securely.