[Previous][Next]
REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operation
  • Rear Combination Light Assembly Removal and Installation (Refer to GROUP 54A, Rear Combination Light ).
  • Overfender (Rear Wheel Arch Molding) Mount (Rear Bumper Side) Removal and Installation (Refer to ).
  • Rear Wheel Splash Shield (Rear Bumper Side) Removal and Installation (Refer to GROUP 42A, Splash Shield ).
  • Rear End Wiring Harness and Rear Bumper Wiring Harness Combination Connector Connection. <Up to 20 Model year>
 
 
Removal steps
>>A<<1.Rear bumper assembly
2.Rear bumper face support bracket
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< REAR BUMPER ASSEMBLY INSTALLATION
Tightening the rear bumper bolts in the numerical order to 5.0 ± 2.0 N·m (44 ± 17 in-lb).
 
 
 
>>A<< REAR BUMPER ASSEMBLY INSTALLATION <VEHICLES WITH BLIND SPOT WARNING AND REAR CROSS TRAFFIC ALERT>
caution
  • Do not apply any sticker, paint or putty to the radar electric wave penetration area (shaded portion). However, only for Mitsubishi motors genuine color, paint can be repaired.
  • Avoid any shocks or scratches.
The electric wave penetration areas are symmetrical on left and right.