42B-FORCED POWER SUPPLY OUTPUT PROCEDURE

FORCED POWER SUPPLY OUTPUT PROCEDURE

With KOS, the power supply cannot be turned ON until the certification communication with keyless operation key is complete. However, using the scan tool (M.U.T.-IIISE), the power can be forced ON even when the certification communication with keyless operation key is not completed. As a result, the error in certification with keyless operation key can be distinguished from the malfunction in power supply. In addition, the process allows the CAN bus diagnostic as well as the reading of DTC, belonging to systems other than KOS, to be performed.

FORCED POWER SUPPLY OUTPUT PROCEDURE

1. Connect the scan tool (M.U.T.-IIISE) to the data link connector.

2. On the scan tool (M.U.T.-IIISE) system selection screen, select F.A.S.T./OSS/IMMO/Keyless.

3. Select Special Function from F.A.S.T./OSS/IMMO/Keyless screen. For vehicles with KOS, select with F.A.S.T.

4. Select Forced power supply output from Special Function screen.

5. From the forced power supply output screen, select the status with which the control is desired (Selection can be made from IG ACC, IG ON, and IG START).

6. On the execution confirmation screen, select "OK."

7. While the process is executed, the selected control status is maintained.

note	During the forced power supply output, the indicator flashes in amber.

8. To cancel the forced power supply output, select Forced power supply output (stop) on the Special Function screen, or operate the engine switch.