35A-STOPLIGHT SWITCH CHECK

STOPLIGHT SWITCH CHECK

caution

Do not apply lubricant (grease or silicon system sprayer etc.) to the switch and the switch installation section to avoid malfunction of the switch. In addition, do not use gloves which have lubricant (grease or silicon system sprayer etc.) on them.

Check for continuity between the terminals of the switch.

Check condition	Terminal connector of tester	Normal condition
At free position	1 - 2 (for stoplight switch)	Continuity exists (2 Ω or less)
At free position	3 - 4 (for cruise control)	No continuity
Press the plunger from the edge of the outer case by the dimension shown in the figure.	1 - 2 (for stoplight switch)	No continuity
	3 - 4 (for cruise control)	Continuity exists (2 Ω or less)