Brake Fluid Supplying and Air Bleeding (Refer to ).
Removal steps
1.
Eye bolt
2.
Gasket
3.
Brake caliper assembly
•
Brake disc run-out check and correction (only at installation) (Refer to ).
<<A>>
4.
Front brake disc
5.
Clip
6.
Brake pipe connection
>>A<<
7.
Brake hose
REMOVAL SERVICE POINT
<<A>> BRAKE DISC REMOVAL
If the brake disc removal is difficult, install bolts (M8 x 1.25 mm) shown in the figure, and tighten them evenly and gradually to remove the brake disc.
INSTALLATION SERVICE POINT
>>A<< BRAKE HOSE INSTALLATION
1. Set the vehicle straight ahead.
2. Connect brake hose to (part A in the figure) brake caliper assembly.
3. Attach the brake hose (part B in the figure) to the bracket.
4. Attach the brake hose (part C in the figure) to the bracket.
5. Pass the brake hose (part D in the figure) through the hole in the body-side bracket.
6. In order to minimize the twist of the brake hose, twist the brake hose in the small twisting direction between the brake hose and the body side bracket as shown in the figure, and clip it to the body side bracket