[Previous][Next]
DATA LIST REFERENCE TABLE
Item No.Display on scan toolCheck conditionsNormal conditions
1Primary speed sensor (Input)
  • Engine: Idling
  • Selector lever position: N
  • After warm-up
More than 0 r/min
2Primary pressure sensor signal
  • Engine: Idling
  • Selector lever position: N
  • After warm-up
0.2 - 0.7 V
3Secondary pressure sensor signal
  • Engine: Idling
  • Selector lever position: N
  • After warm-up
1.4 - 1.9 V
4Vehicle speed sensor signalDriving conditionsNearly the same as the speedometer display
5CVT oil TEMP. sensor signalIgnition switch: ONTransmission fluid temperature: approx. 20°C (68°F)2.01 - 2.05 V
Transmission fluid temperature: approx. 50°C (122°F)1.45 - 1.50 V
Transmission fluid temperature: approx. 80°C (176°F)0.90 - 0.94 V
6Power supply voltageIgnition switch: ONBattery positive voltage
7Solenoid drive voltageIgnition switch: ONBattery positive voltage
8Turbine revolution sensor signal
  • Vehicle speed: Driving at constant speed of 60 km/h (37 mph)
  • Selector lever position: D
  • After warm-up
1,200 - 1,700 r/min
9Primary speed (Control)While the vehicle is drivenNearly the same as the tachometer display
10Secondary speed (Control)While the vehicle is drivenApprox. 48 × Vehicle speed (speedometer display)
11Engine revolutionWhile the vehicle is drivenNearly the same as the tachometer display
12Slip revolution
  • Vehicle speed: Driving at constant speed of 60 km/h (37 mph)
  • Selector lever position: D
-15 to +15 r/min
13Real change gear ratio
  • Vehicle speed: Driving at constant speed of 60 km/h (37 mph)
  • Selector lever position: D
0.4 - 0.7
14Acceleration/deceleration value
  • Vehicle speed: Driving at constant speed of 60 km/h (37 mph)
  • Selector lever position: D
Approx. 0 G
15Accelerator positionAccelerator pedal: Fully closed0%
Accelerator pedal: DepressedOpening angle value increases in response to the depression amount of the accelerator pedal
Accelerator pedal: Fully opened100%
16Real engine torque
  • Vehicle speed: Driving at constant speed of 60 km/h (37 mph)
  • Selector lever position: D
Approx. 40 Nm (30 ft-lb)
17Engine torque (After correction)
  • Vehicle speed: Driving at constant speed of 60 km/h (37 mph)
  • Selector lever position: D
Approx. 40 Nm (30 ft-lb)
18Input torque
  • Vehicle speed: Driving at constant speed of 60 km/h (37 mph)
  • Selector lever position: D
Approx. 40 Nm (30 ft-lb)
19Torque ratio
  • Engine: Idling
  • Selector lever position: P
Approx. 1.0
While the vehicle is drivenValue depends on driving condition
20Primary pressure
  • Engine: Idling
  • Selector lever position: N
  • After warm-up
0.45 - 0.55 MPa (65 - 80 psi)
21Secondary pressure
  • Engine: Idling
  • Selector lever position: N
  • After warm-up
1.0 - 1.2 MPa (145 - 174 psi)
22CVT oil temperatureDriving after engine has warmed upGradually increases
23Vehicle speed (Inference)While the vehicle is drivenNearly the same as the speedometer display
24Real vehicle speedWhile the vehicle is drivenNearly the same as the speedometer display
25Turbine revolution (Control)While the vehicle is drivenNearly the same as the tachometer display
26Target input pulley revolutionWhile the vehicle is drivenNearly the same as the tachometer display
27Target change gear ratio
  • Vehicle speed: 0 km/h (0 mph)
  • Engine: Idling
  • Selector lever position: N
2.631 - 0.378
28Target LU differential pressure
  • Engine: Idling
  • Selector lever position: N
  • After warm-up
Approx. -0.5 MPa (-73 psi)
29Target line pressure
  • Engine: Idling
  • Selector lever position: N
  • After warm-up
1.0 - 1.2 MPa (145 - 174 psi)
30Target primary pressure
  • Engine: Idling
  • Selector lever position: N
  • After warm-up
0.45 - 0.55 MPa (65 - 80 psi)
31Target secondary pressure
  • Engine: Idling
  • Selector lever position: N
  • After warm-up
1.0 - 1.2 MPa (145 - 174 psi)
32Target select pressure
  • Engine: Idling
  • Selector lever position: N
  • After warm-up
Approx. 0 MPa (0 psi)
33Elec.oil pump air bleeding stateNot used.
34Elec.oil pump relay monitorNot used.
35Idling stop active stateNot used.
36Elec.oil pump state signalNot used.
37Elec.oil pump indication signalNot used.
38Elec.oil pump relay outputNot used.
39LU solenoid monitor current
  • Vehicle speed: Driving at constant speed of 60 km/h (37 mph)
  • Selector lever position: D
0.4 - 0.6 A
  • Vehicle speed: 0 km/h (0 mph)
  • Engine: Idling
  • Selector lever position: N
Approx. 0 A
40LU solenoid output currentFrom lockup release to engage0 - 0.7 A
41Line PRS.SOL.monitor current
  • Vehicle speed: 0 km/h (0 mph)
  • Engine: Idling
  • Selector lever position: N
0.8 - 1.0 A
42Line PRS.SOL.output currentFrom low line pressure to high line pressure0 - 0.8 A
43Primary PRS.SOL.monitor current
  • Vehicle speed: 0 km/h (0 mph)
  • Engine: Idling
  • Selector lever position: N
0.7 - 0.9 A
44Primary PRS.SOL.output currentFrom low primary pressure to high primary pressure0 - 0.8 A
45Secondary PRS.SOL.monitor current
  • Engine: Idling
  • Selector lever position: N
0.7 - 0.9 A
Engine: Stalled0 - 0.3 A
46Secondary PRS.SOL.output currentFrom low secondary pressure to high secondary pressure0 - 0.8 A
47Select solenoid monitor current
  • Vehicle speed: Driving at constant speed of 60 km/h (37 mph)
  • Selector lever position: D
0.6 - 0.9 A
48Select solenoid output current
  • Vehicle speed: 0 km/h (0 mph)
  • Engine: Idling
  • Selector lever position: N
Approx. 1.0 A
49Indicator P output
  • Ignition switch: ON
  • Engine: Stopped
Selector lever position: PON
Selector lever position: Other than the aboveOFF
50Indicator R output
  • Ignition switch: ON
  • Engine: Stopped
Selector lever position: RON
Selector lever position: Other than the aboveOFF
51Indicator N output
  • Ignition switch: ON
  • Engine: Stopped
Selector lever position: NON
Selector lever position: Other than the aboveOFF
52Indicator D output
  • Ignition switch: ON
  • Engine: Stopped
Selector lever position: DON
Selector lever position: Other than the aboveOFF
53Indicator Ds outputNot used.
54Indicator L outputNot used.
55Indicator manual mode output
  • Ignition switch: ON
  • Engine: Stopped
Operate the paddle shift lever to activate Sport mode.ON
Operate the paddle shift lever to deactivate Sport mode.OFF
56Gear position (Manual mode)Operate the paddle shift lever to activate Sport mode.Idling1st
Drive at a constant speed of 30 km/h (19 mph) in 2nd gear.2nd
Drive at a constant speed of 35 km/h (22 mph) in 3rd gear.3rd
Drive at a constant speed of 40 km/h (25 mph) in 4th gear.4th
Drive at a constant speed of 50 km/h (31 mph) in 5th gear.5th
Drive at a constant speed of 60 km/h (37 mph) in 6th gear.6th
Drive at a constant speed of 70 km/h (43 mph) in 7th gear.7th
Drive at a constant speed of 90 km/h (56 mph) in 8th gear.8th
57Idle switch signal
  • Ignition switch: ON
  • Engine: Stopped
Accelerator pedal: Fully closedON
Accelerator pedal: DepressedOFF
58Ds switchNot used.
59Brake switch
  • Ignition switch: ON
  • Engine: Stopped
Brake pedal: DepressedON
Brake pedal: Released OFF
60Transmission range switch: P
  • Ignition switch: ON
  • Engine: Stopped
Selector lever position: PON
Selector lever position: Other than the aboveOFF
61Transmission range switch: R
  • Ignition switch: ON
  • Engine: Stopped
Selector lever position: RON
Selector lever position: Other than the aboveOFF
62Transmission range switch: N
  • Ignition switch: ON
  • Engine: Stopped
Selector lever position: NON
Selector lever position: Other than the aboveOFF
63Transmission range switch: D
  • Ignition switch: ON
  • Engine: Stopped
Selector lever position: DON
Selector lever position: Other than the aboveOFF
64Manual mode switch
  • Ignition switch: ON
  • Engine: Stopped
Selector lever position: Sport modeON
Selector lever position: Other than the aboveOFF
65Select switch (Up)
  • Ignition switch: ON
  • Engine: Stopped
Selector lever position: Upshift and holdON
Selector lever position: Other than the aboveOFF
66Select switch (Down)
  • Ignition switch: ON
  • Engine: Stopped
Selector lever position: Downshift and holdON
Selector lever position: Other than the aboveOFF
67Paddle switch (Up)
  • Ignition switch: ON
  • Engine: Stopped
Paddle shift lever position: Upshift and holdON
Paddle shift lever position: Other than the aboveOFF
68Paddle switch (Down)
  • Ignition switch: ON
  • Engine: Stopped
Paddle shift lever position: Downshift and holdON
Paddle shift lever position: Other than the aboveOFF
69ABS actuation signalABS operatedON
ABS not operatedOFF
70TCL actuation signalTCL operatedON
TCL not operatedOFF
71A.S.C. actuation signalASC operatedON
ASC not operatedOFF
72Shift position
  • Ignition switch: ON
  • Engine: Stopped
Selector lever position: PP, N
Selector lever position: RR
Selector lever position: NP, N
Selector lever position: DD
73Inhibitor SW :LNot used.