15-TURBOCHARGER WASTE GATE ACTUATOR CHECK

TURBOCHARGER WASTEGATE ACTUATOR CHECK

RESISTANCE BETWEEN TERMINALS CHECK

1. Disconnect the turbocharger wastegate actuator connector.

2. Check the continuity of the locations in the table below and check the normal condition. If it is bad, replace the turbocharger assembly.

Terminal connector of tester	Electrical continuity
4-1	No continuity
4-2
4-3
4-6	Continuity

Terminal connector of tester	Electrical continuity
5-3	No continuity
5-2
5-4
5-1	Continuity

OPERATION CHECK

note	Confirm open circuit and looseness for the harness and connector before operation check.

1. At IG-ON, check that the turbocharger wastegate actuator rod moves. If the turbocharger wastegate actuator rod is not moving, replace the turbocharger assembly.