[Previous][Next]
DTC C2335 Vehicle speed not determined
 
 
cautionBefore replacing the ECU, ensure that the power supply circuit, the ground circuit and the communication circuit are normal.
 
 
OPERATION
The BSW-ECU (master) communicates with the ASC-ECU via the gateway-ECU and CAN bus lines.
 
 
CHECK CONDITION
Ignition switch is in the "ON" position.
 
 
DIAGNOSTIC FUNCTION AND TROUBLE JUDGMENT
When the BSW-ECU (master) receives any invalid vehicle speed signal or any implausible signal from the ASC-ECU, the ECU sets DTC C2335.
 
 
TROUBLESHOOTING HINTS
  • The ASC system fails
  • Malfunction of BSW-ECU (master)
 
 
DIAGNOSIS
STEP 1. Using scan tool (M.U.T.-IIISE), read the other system DTC.
Check if DTC is set in the ASC-ECU.
(1)
cautionTo prevent damage to scan tool (M.U.T.-IIISE), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-IIISE).
Connect scan tool (M.U.T.-IIISE). Refer to "How to connect the Scan Tool (M.U.T.-IIISE) ."
(2) Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
(3) Check if the DTC is set.
Is the DTC set?
Troubleshoot the ASC-ECU.
Go to Step 2.
 
STEP 2. Using scan tool (M.U.T.-IIISE), read the DTC again.
Check again if the DTC is set in the BSW-ECU (master).
(1) Erase the DTC.
(2) Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
(3) Check if the DTC is set.
Is the DTC set?
Replace the ASC-ECU (Refer to GROUP 35C - Hydraulic Unit Removal and Installation ). Then go to Step 3.
Intermittent malfunction is suspected (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).
 
STEP 3. Using scan tool (M.U.T.-IIISE), read the DTC again.
Check again if the DTC is set in the BSW-ECU (master).
(1) Erase the DTC.
(2) Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
(3) Check if the DTC is set.
Is the DTC set?
Replace the BSW-ECU (master).
This diagnosis is complete.