[Previous][Next]
DTC C2334 SAS neutral point not learned
 
 
cautionBefore replacing the ECU, ensure that the power supply circuit, the ground circuit and the communication circuit are normal.
 
 
OPERATION
The BSW-ECU (master) communicates with the steering wheel sensor via the gateway-ECU and the CAN bus lines.
 
 
CHECK CONDITION
Ignition switch is in the "ON" position.
 
 
DIAGNOSTIC FUNCTION AND TROUBLE JUDGMENT
When the BSW-ECU (master) receives the signal, which indicates that the neutral position of the steering wheel sensor has not been learnt yet, the ECU will set DTC C2334.
 
 
TROUBLESHOOTING HINTS
  • Neutral position of steering wheel sensor not learned
  • Malfunction of the steering wheel sensor (incorporated in column switch assembly)
  • Malfunction of BSW-ECU (master)
 
 
DIAGNOSIS
1. Steering wheel sensor calibration (Refer to GROUP 35C - Steering Wheel Sensor Calibration ).
2. Check whether the DTC is set again.