[Previous][Next]
DTC U1190 No receive fault detect signal
 
 
caution
  • If diagnostic trouble DTC U1190 is set, diagnose the CAN bus lines.
  • When replacing the ECU, always check that the communication circuit is normal.
 
 
JUDGMENT CRITERIA
ETACS-ECU sends the DTC (U code) detection permission or prohibition signal to each ECU connected to the CAN bus line. If the gateway-ECU cannot receive the DTC (U code) detection permission or prohibition signal for 5 seconds after turning the ignition switch to "ON" position, DTC U1190 will be set.
 
 
PROBABLE CAUSES
  • Malfunction of the ETACS-ECU
  • Malfunction of CAN bus line
  • Malfunction of the gateway-ECU
 
 
DIAGNOSIS
1. Using scan tool (M.U.T.-IIISE), diagnose the CAN bus line
2. Using scan tool (M.U.T.-IIISE), read the other system diagnostic trouble code
3. Diagnostic trouble code recheck