[Previous][Next]
DTC B1869: TCU Internal Error
 
 
cautionWhen replacing the ECU, always check that the communication circuit is normal.
 
 
TROUBLE JUDGMENT
Check Conditions
  • Ignition switch: ON
Judgment Criterion
  • When the TCU detects the internal error.
 
 
TROUBLESHOOTING HINTS
  • The TCU may be defective
 
 
DIAGNOSIS
Using scan tool (M.U.T.-IIISE), check whether the DTC is set again.
Check again if the DTC is set in the TCU.
(1)
cautionTo prevent damage to scan tool (M.U.T.-IIISE), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-IIISE).
Connect scan tool (M.U.T.-IIISE). Refer to "How to connect the Scan Tool (M.U.T.-IIISE) ."
(2) Erase the DTC.
(3) Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
(4) Check the DTC.
Is the DTC set?
Replace the TCU (Refer to ).
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction ).