[Previous][Next]
DTC B1E21 Roomlight deactivated (FET failure)
 
 
cautionBefore replacing the ECU, ensure that the power supply circuit, the ground circuit and the communication circuit are normal.
 
 
DIAGNOSTIC FUNCTION
DTC B1E21 will be set when the ETACS-ECU detects an internal fault at LO side of the dome light.
 
 
TECHNICAL DESCRIPTION (COMMENT)
DTC B1E21 will be set when the ETACS-ECU detects a internal fault at LO side of the dome light.
 
 
TROUBLESHOOTING HINTS
  • Damaged harness wires and connectors
  • Malfunction of the ETACS-ECU
 
 
DIAGNOSIS
Using scan tool (M.U.T.-IIISE), read the other DTC again.
Check again if DTC B1E1E is set in the ETACS-ECU.
(1)
cautionTo prevent damage to scan tool (M.U.T.-IIISE), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-IIISE).
Connect scan tool (M.U.T.-IIISE). Refer to "How to connect Scan Tool (M.U.T.-IIISE) ."
(2) Erase the DTC.
(3) Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
(4) Check if DTC is set.
Is the DTC set?
Carry out the troubleshooting for DTC B1E1E. On completion, replace the ETACS-ECU when it has not been replaced as the troubleshooting process for DTC B1E1E. This is because DTC B1E21 cannot be erased.
Replace the ETACS-ECU.