[Previous][Next]
Inspection Procedure 5: A screen is not switched when the vehicle speed reaches a predetermined value.
 
 
 
 
TECHNICAL DESCRIPTION (COMMENT)
The camera-ECU switches the monitor screen according to a vehicle speed signal. If it is not switched, the vehicle speed signal system may be defective.
 
 
TROUBLESHOOTING HINTS
  • The camera-ECU may be defective
  • The CAN bus may be defective
  • Damaged harness wires and connectors
 
 
DIAGNOSIS
STEP 1. Using scan tool (M.U.T.-IIISE), diagnose CAN bus line.
(1)
cautionTo prevent damage to scan tool (M.U.T.-IIISE), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-IIISE).
Connect scan tool (M.U.T.-IIISE). Refer to "How to connect the Scan Tool (M.U.T.-IIISE) ."
(2) Turn the ignition switch to the "ON" position.
(3) Diagnose the CAN bus line.
(4) Turn the ignition switch to the "LOCK" (OFF) position.
Is the CAN bus line found to be normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting - CAN Bus Diagnostics Table ).
 
STEP 2. Using scan tool (M.U.T.-IIISE), check data list.
Using the camera-ECU service data.
  • Perform a test run of the vehicle.
 
Item No.Scan tool (M.U.T.-IIISE) displayCheck conditionNormal condition
4Vehicle speed informationRunningEnable
Item No.Scan tool (M.U.T.-IIISE) displayCheck conditionNormal condition
4Vehicle speed informationRunningEnable
Is the check result normal?
Go to Step 4.
Go to Step 3.
 
STEP 3. Using scan tool (M.U.T.-IIISE), check whether the other system DTC is set.
Check if a vehicle speed signal-related DTC is set in the ETACS-ECU (Refer to ).
Is the DTC set?
Diagnose the ETACS-ECU (Refer to ).
Go to Step 4.
 
STEP 4. Retest the system.
Is the check result normal?
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).
Replace the camera-ECU (Refer to ).