STEP 1. Check of short circuit in TL1 line between ETACS-ECU connector and front turn-signal light (LH) connector.
STEP 2. Check of short circuit in TL3 line between ETACS-ECU connector and rear combination light (TURN: LH) connector.
STEP 3. Check of short circuit in TL2 line between ETACS-ECU connector and door mirror assembly (LH) connector.
STEP 4. Using scan tool (M.U.T.-IIISE), read the DTC again.
(1) caution | To prevent damage to scan tool (M.U.T.-IIISE), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-IIISE). |
Connect scan tool (M.U.T.-IIISE). Refer to "How to connect Scan tool (M.U.T.-IIISE)
."
(2) Erase the DTC.
(3) Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
(4) Check if DTC is set.
Is the DTC set?
Replace the ETACS-ECU. The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction ).