[Previous][Next]
DIAGNOSTIC TROUBLE CODE CHART
cautionOn troubleshooting, if the ignition switch is turned "ON" while disconnecting connector(s), DTC(s) associated with other system may be set. On completion, confirm all systems for DTC(s). If DTC(s) are set, erase them all.
ETACS-ECU
DTC No.Diagnostic itemReference page
B1E11Low Beam Light(RH) Open Load or Blown Error
B1E12Low Beam Light(LH) Open Load or Blown Error
B1E13Low Beam Light(RH) Overload or Short Circuit
B1E14Low Beam Light(LH) Overload or Short Circuit
B1E15Low Beam Light(RH) deactivated (FET failure)
B1E16Low Beam Light(LH) deactivated (FET failure)
B1E2AMultichannel Driver CH6 Defective (Open/Short)
LIN <VEHICLES WITH LIGHTING CONTROL SENSOR>
DTC No.Diagnostic itemReference page
L0434RLS* Light sensor error <Vehicles with lighting control sensor>
L0436RLS* Rain sensor error <Vehicles with lighting control sensor>
L0444RLS* Battery voltage high error <Vehicles with lighting control sensor>
L0446RLS* Battery voltage low error <Vehicles with lighting control sensor>
note*: Rain light sensor (Lighting control sensor)