[Previous][Next]
DTC B1418: Front impact sensor (LH) communication error
DTC B1419: Front impact sensor (LH) communication impossible
 
 
cautionIf DTC B1418 or B1419 is set in the SRS-ECU, always diagnose the CAN main bus line.
 
 
OPERATION
The front impact sensor (LH) transmits acceleration data to the SRS-ECU. The SRS-ECU then determines whether to operate the front air bags, and then outputs an ignition signal when necessary. The front impact sensor (LH) also diagnoses itself, and sends a DTC to the SRS-ECU if a malfunction occurs
 
 
DTC SET CONDITIONS
The DTC is set if the communication between the left front impact sensor (LH) and SRS-ECU is abnormal (DTC B1418), or impossible (DTC B1419).
 
 
PROBABLE CAUSES
  • Damaged wiring harnesses or connectors
  • Malfunction of the front impact sensor (LH)
  • Malfunction of the SRS-ECU
 
 
DIAGNOSIS
STEP 1. Using scan tool (M.U.T.-IIISE), diagnose the CAN bus line.
(1)
cautionTo prevent damage to scan tool (M.U.T.-IIISE), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-IIISE).
Connect scan tool (M.U.T.-IIISE). Refer to "How to connect the scan tool ."
(2) Turn the ignition switch to the "ON" position.
(3) Diagnose the CAN bus line.
(4) Turn the ignition switch to the "LOCK" (OFF) position.
Is the CAN bus line found to be normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C, Diagnosis ).
 
STEP 2. Using scan tool (M.U.T.-IIISE), check whether the DTC is set again.
(1) Connect the negative battery terminal.
(2) After erasing the DTC memory, check the DTC again.
(3) Disconnect the negative battery terminal.
Is DTC B1418 or B1419 set?
Go to Step 3.
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).
 
STEP 3. Check the front impact sensor (LH).
(1) Check that the negative battery terminal is disconnected. If the negative battery terminal is connected, disconnect it.
(2) Alternate the front impact sensor (LH) and the front impact sensor (RH), and then install the alternated sensor.
(3) Connect the negative battery terminal.
(4) After erasing the DTC memory, check the DTC again.
(5) Disconnect the negative battery terminal.
Is DTC B1418 or B1419 set?
Replace the front impact sensor (LH) (Refer to ).
Go to Step 4.
 
STEP 4. Check of short to power supply, short to ground, and open circuit in FLH-, FLH+ line between SRS-ECU connector and front impact sensor (LH) connector.
noteAfter inspecting intermediate connector inspect the wiring harness. If the intermediate connector is damaged, repair or replace it.
Is the check result normal?
Go to Step 5.
Repair the wiring harness.
 
STEP 5. Using scan tool (M.U.T.-IIISE), check whether the DTC is set again.
Is DTC B1418 or B1419 set?
Replace SRS-ECU (Refer to ).
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).