[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Pre-removal and Post-installation Operation
  • Liftgate Trim Removal and Installation (Refer to GROUP 52A, Liftgate Trim ).
  • Liftgate Lock Release Handle Removal and Installation (Refer to GROUP 42A, Liftgate Handle and Latch ).
Removal step
<<A>>>>A<<1.License light garnish
2.Three-diamond mark
3.Slide nut
4.Cushion
    Required special tools:
  • MB990784: Ornament remover
 
 
REMOVAL SERVICE POINTS
 
 
<<A>> LICENSE LIGHT GARNISH REMOVAL
1. Use a 6 mm (0.2 inch) socket wrench to remove the three clips from the inside of the vehicle.
2. Insert the special tool Ornament Remover (MB990784) through the opening of the left license light to lift the license light garnish.
3.
cautionDo not let the special tool Ornament Remover (MB990784) contact the extra window lower molding directly. If the special tool Ornament Remover (MB990784) contacts the extra window lower molding, protect it with a tape.
Insert the special tool Ornament Remover (MB990784) to the center of the license light garnish and slide it toward the outside to remove the clip.
4.
cautionBe careful not to let the special tool Ornament Remover (MB990784) get into the slit of the clip base.
Insert the special tool Ornament Remover (MB990784) to the position shown to remove the clip on the outer lower side of the license light garnish.
 
 
 
 
INSTALLATION SERVICE POINTS
 
 
>>A<< LICENSE LIGHT GARNISH INSTALLATION
cautionWhen installing the license light garnish, roll up the extra window lower molding and secure it with a tape to prevent it from getting caught.