[Previous][Next]
DTC B2400 KOS key registration fail
 
 
caution
  • Keyless operation key cannot be registered to another vehicle.
  • Only the keys, which are designed for ECLIPSE CROSS, can be registered.
  • If commercial electric products are connected, communication with the keyless operation key cannot be performed normally, and the key registration may fail. When performing the registration, disconnect all the commercial electric products.
  • If DTC B2400 is set, diagnose the CAN bus lines.
  • When replacing the ECU, always check that the communication circuit is normal.
 
 
DIAGNOSIS FUNCTION
If the registration of the keyless operation key to KOS&OSS-ECU fails, KOS&OSS-ECU sets DTC B2400.
 
 
JUDGMENT CRITERIA
If the registration of the keyless operation key ID fails, KOS&OSS-ECU determines that there is a problem.
 
 
PROBABLE CAUSES
  • Keyless operation key is registered to another vehicle
  • Keys are not designed for ECLIPSE CROSS.
  • At the registration, there is an object near the keyless operation key which interferes with the communication.
  • Wrong keyless operation key registration method
  • Failure of keyless operation key code registration
  • Battery drain of keyless operation key
  • Malfunction of the keyless operation key
  • Malfunction of CAN bus line
  • Malfunction of KOS&OSS-ECU
 
 
DIAGNOSIS
STEP 1. Interference check at keyless operation key registration.
At the keyless operation key registration, check if there is another key nearby or anything that interferes with the communication (magnets or objects that generate radio waves such as air-cleaning devices with a power plug).
Are there other keys or anything that interferes with the communication?
Move away or remove other keys or anything that interferes with the communication.
Go to Step 2.
 
STEP 2. Check of keyless operation key registration method.
Check that the correct method was used at the registration of keyless operation key.
Is the check result normal?
Go to Step 3.
Register the keyless operation key (Refer to ).
 
STEP 3. Using scan tool (M.U.T.-IIISE), diagnose the CAN bus line
Use scan tool (M.U.T.-IIISE) to diagnose the CAN bus lines.
Is the check result normal?
Go to Step 4.
Repair the CAN bus line (Refer to GROUP 54C - Diagnosis ). On completion, go to Step 4.
 
STEP 4. Using scan tool (M.U.T.-IIISE), check the DTC.
Check if any DTC is set in the KOS&OSS-ECU.
Is the DTC set?
Refer to DTC chart .
Go to Step 5.
 
STEP 5. Register the keyless operation key again and recheck the DTC.
(1) Register the keyless operation key again.
(2) Check if the DTC is set.
Is the DTC set?
Replace KOS&OSS-ECU and register the ID codes (Refer to ).
The diagnosis is complete.