[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Waterproof film removal steps 
•Door trim assembly (Refer to GROUP 52A, Door Trim )
>>B<<1.Waterproof film
Door speaker bracket removal steps
•Door trim assembly (Refer to GROUP 52A, Door Trim )
>>B<<1.Waterproof film
2Door speaker bracket
Door working hole cover front and door working hole cover rear removal
•Door trim assembly (Refer to GROUP 52A, Door Trim )
>>B<<1.Waterproof film
3.Door working hole cover front
4.Door working hole cover rear
Door window glass runchannel removal
5.Door window glass runchannel
Door window glass runchannel rear removal
•Door trim assembly (Refer to GROUP 52A, Door Trim )
>>B<<1.Waterproof film
2Door speaker bracket
3.Door working hole cover front
4.Door working hole cover rear
6.Door window rear lower sash
7.Door window glass runchannel rear
Door sash molding removal steps
8.Door sash molding
Door beltline molding removal steps
<<A>>9.Door beltline molding
Door opening weatherstrip lower removal steps
10.Door opening weatherstrip lower
Door opening weatherstrip outer removal steps
<<B>>11.Door opening weatherstrip outer
Door opening weatherstrip inner removal steps
•Cowl side trim and front scuff plate (Refer to GROUP 52A, Interior Trim )
12.Door check connecting bolt
>>A<<13.Door opening weatherstrip inner
 
 
Waterproof film removal steps 
•Door trim assembly (Refer to GROUP 52A, Door Trim )
>>B<<1.Waterproof film
Door speaker bracket removal steps
•Door trim assembly (Refer to GROUP 52A, Door Trim )
>>B<<1.Waterproof film
2.Door speaker bracket
Door working hole cover removal
•Door trim assembly (Refer to GROUP 52A , Door Trim )
>>B<<1.Waterproof film
3.Door working hole cover
Door sash molding removal steps
4.Door sash molding
Door beltline molding removal steps
<<A>>5.Door beltline molding
Door window glass runchannel removal
6.Door window glass runchannel
Door window glass runchannel sash removal
•Door trim assembly (Refer to GROUP 52A, Door Trim )
>>B<<1.Waterproof film
2.Door speaker bracket
3.Door working hole cover
5.Door window beltline molding
6.Door window glass runchannel
7.Door window rear lower sash
Door opening weatherstrip outer removal steps
<<B>>8.Door opening weatherstrip outer
Door opening weatherstrip inner removal steps
•Cowl side trim and front scuff plate (Refer to GROUP 52A, Interior Trim )
9.Door check connecting bolt
>>A<<10.Door opening weatherstrip inner
 
 
REMOVAL SERVICE POINTS
 
 
<<A>> DOOR BELTLINE MOLDING REMOVAL
Insert a flat-tipped screwdriver as shown, and pry it in the direction shown to remove the door beltline molding.
 

 
 
<<B>> DOOR OPENING WEATHERSTRIP OUTER REMOVAL
Make the tool as shown in the figure, and remove the weatherstrip from the door panel.
 
 
 
 
INSTALLATION SERVICE POINTS
 
 
>>A<< DOOR OPENING WEATHERSTRIP INNER INSTALLATION
Align the mark on the door opening weatherstrip inner with the notch at the vehicle bode side as shown.
 

 
 
>>B<< WATERPROOF FILM INSTALLATION
cautionWhen a waterproof film is applied, guide the butyl rubber tape under the inner panel drain hole.
Apply the specified adhesive to the water-proof film as shown in the figure and stick the film.
Specified sealant: 3M ATD Part No. 8625 or equivalent