[Previous][Next]
REAR WHEEL ALIGNMENT CHECK AND ADJUSTMENT
1. Before the wheel alignment measurement, adjust the rear suspension, wheel, and tires in good condition.
2. Park the vehicle on a level surface to measure the wheel alignment.
 
 
 
 
TOE-IN
Standard value:
  • At the center of tire tread: 3 ± 2 mm (0.12 ± 0.08 inch)
  • Toe-angle (per wheel): 0°08’ ± 0°05’
If it is out of the standard range, adjust as follows:
Turn the toe adjusting bolt (the mounting bolt inside the body on the control link) to adjust.
Left wheel: Clockwise (+) Toe in
Right wheel: Clockwise (-) Toe in
Toe-in varies approximately 3.2 mm (0.13 inch) (equivalent to 0°16' of the toe angle for one side) for each scale mark.
 
 
 
 
CAMBER
Standard value: -0°40' ± 0°45'
note
  • Difference between right and left wheels must be 0°30' or less.
  • The camber is pre-adjusted at factory and is not adjustable.
  • As for vehicles with aluminum wheel, use a compensator to measure the camber and caster.