[Previous][Next]
TURBOCHARGER ASSEMBLY INSPECTION
 
 
 
 
TURBOCHARGER ASSEMBLY CHECK
1. Visually check the turbine wheel and the compressor wheel for cracking or other damage.
2. Check whether the turbine wheel and the compressor wheel can be easily turned by hand.
3. Check for oil leakage from the turbocharger assembly.
noteWhen the turbocharger wastegate valve is usual, it controls it as follows.
Ignition switch "Lock" (OFF) position: Open
Ignition switch "ON" position: Close
 
 
DISTORTION CHECK
1. Check the turbocharger for damage and cracks, and replace it if necessary.
2. Using a straight edge and a thickness gauge, check for distortion of the cylinder head and turbocharger installation surface.
  • Limit:
  • 0.70 mm (0.028 inch) or less <Cylinder head side>
  • 0.40 mm (0.016 inch) or less <Turbocharger side>