[Previous] [Next]

DTC P1876: Gear Block 1st


caution
  • If there is any problem in the CAN bus lines, an incorrect diagnostic trouble code may be set. Prior to this diagnosis, diagnose the CAN bus lines.
  • Whenever the ECU is replaced, ensure that the CAN bus lines are normal.

DIAGNOSTIC FUNCTION


TC-SST-ECU checks that the gear engagement is normal.

DESCRIPTIONS OF MONITOR METHODS


The engagement of the 1st gear is determined to be impossible.

PROBABLE CAUSES



DIAGNOSTIC PROCEDURE
Required Special Tools:
  • MB991958 Scan Tool (M.U.T.-III Sub Assembly)

    • MB991824: Vehicle Communication Interface (V.C.I.)
    • MB991827 M.U.T.-III USB Cable
    • MB991910 M.U.T.-III Main Harness A

STEP 1. Scan tool CAN bus diagnostics
Using scan tool MB991958, diagnose the CAN bus lines.

Q. Is the check result normal?
Go to Step 2.
Repair the CAN bus lines. (Refer to GROUP 54C - Troubleshooting .) After repairing the CAN bus line, go to Step 2.

STEP 2. Check the fluid.

Q. Is the fluid level proper?
Go to Step 3.
Add the fluid.

STEP 3. Check whether the DTC is reset.
(1)Erase the DTC.
(2)With the engine idle status, operate the shift lever in the following sequence: P → R → D → R → P. (Hold each range for 5 seconds or more.)
(3)Check that the DTC is reset.

Q. Is DTC No.P1876 set?
Replace the transaxle assembly. (Refer to .)
Intermittent malfunction. (Refer to GROUP 00 - How to Cope with Intermittent Malfunction .)