|
|
Turn the ignition switch to the ACC position and then pull the key interlock cable out from the ignition key cylinder.
|
|
|
Turn the ignition switch to the ACC position and then install the key interlock cable to the ignition key cylinder.
|
|
|
1.Move the shift lever to the P position, and turn the ignition switch to the LOCK (OFF) position.
|
|
2.Install the tip of key interlock cable to the lock cam pin of shift lever assembly, using a caution not to twist the inner cable.
3.Install the adjuster case with its lock guide pulled up (unlocked).
4.With the lock cam pin pushed in the direction B as shown in the figure to remove the slack from the key interlock cable, securely lower the lock guide and lock it.
| note |
The lock position of the key interlock cable is automatically adjusted by a spring.
|
|
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
)
)
