[Previous] [Next]

DTC B2463: Sticking of rheostat switch


TROUBLE JUDGEMENT


If the combination meter detects the rheostat switch pressed state for 60 seconds or more continuously, DTC B2463 is stored.

TROUBLESHOOTING HINTS



DIAGNOSIS PROCEDURE
Required Special Tools:
  • MB991958: Scan Tool (M.U.T.-III Sub Assembly)

    • MB991824: Vehicles Communication Interface (V.C.I.)
    • MB991827: M.U.T.-III USB Cable
    • MB991910: M.U.T.-III Main Harness A (Vehicles with CAN communication system)

STEP 1. Check the rheostat switch.
Check whether an abnormality is present to the combination meter and the rheostat switch knob attached to the combination meter bezel.

Q. Is the check result normal?
Go to Step 2.
Replace the combination meter or combination meter bezel.

STEP 2. Using scan tool MB991958, read the combination meter diagnostic trouble code.
Check if DTC is set to the combination meter.

(1)
caution To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.
Connect scan tool MB991958. Refer to "How to connect the Scan Tool (M.U.T.-III) ."
(2)Turn the ignition switch to the "ON" position.
(3)Erase the DTC.
(4)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
(5)Check if diagnosis code is set.

Q. Is the DTC set?

Replace the combination meter, and then go to Step 3.

The procedure is complete.

STEP 3. Recheck for diagnostic trouble code.
Check if DTC is set to the combination meter.
(1)Erase the DTC.
(2)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
(3)Check if diagnosis code is set.

Q. Is the DTC set?
Go to Step 1.
The procedure is complete.