DISASSEMBLY AND ASSEMBLY

Disassembly steps 1. Front grille side cover 2. Radiator grille 3. Front three-diamond mark 4. Hood weatherstrip front <<A>> >>A<< 5. Rivet 6. Front bumper reinforcement 7. Front bumper support 8. Front bumper grille · Front fog light connector connection 9. Front bumper harness 10. Air dam skirt panel 11. Air intake bezel <Vehicles without front fog lights> 12. Front fog light bezel <Vehicles with front fog lights> 13. Front fog light <Vehicles with front fog lights> 14. Front bumper cover 15. Front bumper face

Disassembly steps 1. Front grille side cover 2. Front three-diamond mark 3. Hood weatherstrip front <<A>> >>A<< 4. Rivet 5. Front bumper reinforcement 6. Front bumper support 7. Radiator grille 8. RALLIART mark 9. Front bumper grille 10. Front bumper center garnish · Front fog light connector connection 11. Front bumper harness 12. Front fog light bezel 13. Front fog light 14. Front bumper cover 15. Front bumper face

Use a drill (Φ 4.0 mm) to make a hole in the rivet to break it, and remove the rivet.

Use a rivet tool shown in the illustration to connect the parts with rivets by the following procedures. 1.Insert the rivet into a corresponding location. 2.Set the rivet tool at a section A of rivet. 3.While pushing the flange surface of the rivet onto parts to be fixed with the rivet tool, press the handle of the tool. 4.Thin part of section A of the rivet will be cut off and the parts is fixed in position.