|
Required Special Tools:
- MB991958: Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: Vehicle Communication Interface (V.C.I.)
- MB991827: M.U.T.-III USB Cable
- MB991910: M.U.T.-III Main Harness A
|

|
(1)
caution |
To prevent damage to scan tool (MB991958), always turn the ignition switch to the "LOCK"
(OFF) position before connecting or disconnecting scan tool (MB991958).
|
Connect scan tool MB991958 to the data link connector. (2)Turn the ignition switch to the "ON" position. (3)Diagnose the CAN bus line. (4)Turn the ignition switch to the "LOCK" (OFF) position.
Q.
Is the CAN bus line found to be normal?
Go to Step 2.
Repair the CAN bus line. (Refer to GROUP 54C, Diagnosis ).
|
|
Check if a coding-related DTC is set in the ETACS-ECU.
|
|
Troubleshoot the ETACS. (Refer to GROUP 54A, Diagnosis .)
|
|
|
|
Check again if the DTC is set to the WCM.
|
|
(2)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
|
|
(4)Turn the ignition switch to the "LOCK" (OFF) position.
|
|
Replace WCM and register the ID codes. (Refer to .)
|
|
|
|
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How
to use Troubleshooting/inspection Service Points - How to Cope with Intermittent
Malfunction ).
|
|
|