[Previous] [Next]

DTC C1611: AWC Pressure Sensor System (Low Voltage)










caution
  • If there is any problem in the CAN bus lines, an incorrect diagnostic trouble code may be set. Prior to this diagnosis, diagnose the CAN bus lines.
  • Whenever the ECU is replaced, ensure that the CAN bus lines are normal.

OPERATION


AWC-ECU controls the electric pump by the information from AWC pressure sensor.

DTC SET CONDITIONS


The code is set when AWC pressure sensor output voltage is less than 0.2 V.

PROBABLE CAUSES



DIAGNOSTIC PROCEDURE

STEP 1. Scan tool CAN bus diagnostics
Using scan tool MB991958, diagnose the CAN bus lines.

Q. Is the check result normal?
Go to Step 3.
Repair the CAN bus lines. (Refer to GROUP 54C - Troubleshooting ). After repairing the CAN bus line, go to Step 2.

STEP 2. Check whether the DTC is reset.

Q. Is DTC No. C1611 set?
Go to Step 3.
This diagnosis is complete.

STEP 3. AWC-ECU connector, intermediate connector, AWC pressure sensor connector check: C-51, D-11, F-27

Q. Is the check result normal?
Go to Step 4.
Repair the defective connector. Then go to Step 7.

STEP 4. Check the wiring harness between C-51 AWC-ECU connector terminal No.7 and F-27 AWC pressure sensor connector terminal No.2.
Check the output line for open or short circuit.

Q. Is the check result normal?
Go to Step 5.
Repair the wiring harness. Then go to Step 7.

STEP 5. Scan tool data list
Item No.87: Pressure sensor output voltage.
OK: 0.20 - 2.67 V

Q. Is the check result normal?
Go to Step 6.
Replace the hydraulic unit. (Refer to ) Then go to Step 6.

STEP 6. Check whether the DTC is reset.

Q. Is DTC No. C1611 set?
Replace the AWC-ECU. (Refer to ). Then, go to Step 7.
Intermittent malfunction. (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).

STEP 7. Check whether the DTC is reset.

Q. Is DTC No. C1611 set?
Return to Step 1.
This diagnosis is complete.