[Previous] [Next]

DTC P2228: Barometric Pressure Circuit Low Input




TECHNICAL DESCRIPTION





DESCRIPTIONS OF MONITOR METHODS




MONITOR EXECUTION




MONITOR EXECUTION CONDITIONS (Other monitor and Sensor)


Other Monitor (There is no temporary DTC stored in memory for the item monitored below)
Sensor (The sensor below is determined to be normal)

DTC SET CONDITIONS


Logic Flow Chart

Check Conditions
Judgement Criterion

FAIL-SAFE AND BACKUP FUNCTION




OBD-II DRIVE CYCLE PATTERN




TROUBLESHOOTING HINTS (The most likely causes for this code to be set are:)




DIAGNOSIS


Required Special Tools:
  • MB991958: Scan Tool (M.U.T.-III Sub Assembly)

    • MB991824: V.C.I.
    • MB991827: USB Cable
    • MB991910: Main Harness A

STEP 1. Test the OBD-II drive cycle.



caution To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.
(1)Connect scan tool MB991958 to the data link connector.
(2)Turn the ignition switch to the "ON" position.
(3)Carry out the test drive with the drive cycle pattern. Refer to Diagnostic Function - OBD-II Drive Cycle - Pattern 23 .
(4)Check the diagnostic trouble code (DTC).

Q. Is DTC P2228 set?

Replace the ECM. When the ECM is replaced, register the ID code. Refer to GROUP 42B, Diagnosis - ID Code Registration Necessity Judgment Table <Vehicles with KOS> or GROUP 42C, Diagnosis - ID Codes Registration Judgment Table <Vehicles with WCM> .

It can be assumed that this malfunction is intermittent. Refer to GROUP 00, How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions .