[Previous][Next]
DIAGNOSTIC TROUBLE CODE CHART
caution
  • During troubleshooting, a DTC associated with other system may be stored when the ignition switch is turned on with connector(s) disconnected. On completion, check all systems for DTCs. If DTCs are stored, erase them all.
  • When the combination meter is required to be replaced as a result of the troubleshooting, the current driving distance and number of elapsed days to be used for service reminder function must be entered into the meter after the replacement. Therefore, read "Integrated mileage for reminder," "Integrated days for reminder," "Mileage until Extra reminder," "Months until Extra reminder," and "Current Schedule" from the meter before the replacement using the special function of scan tool (M.U.T.-III), and note them. For the operation method of scan tool (M.U.T.-III), refer to . If "Integrated mileage for reminder" or "Integrated days for reminder" cannot be read by the scan tool (M.U.T.-III), follow the method described below.
    1. For the driving distance for check warning, use the driving distance displayed on the multi information display.
    2. For the elapsed days for check warning, calculate the number of elapsed days from the delivery date to the customer (service remainder function start date) and current date.
DTC No.Diagnostic itemReference page
B1200Odometer failure
B1201Fuel information problem
B1209Test mode
B2463Rheostat switch sticking
U0100Engine CAN timeout
U0101T/M CAN timeout
U0121ABS/ASC CAN timeout
U0131EPS CAN timeout
U0141ETACS CAN timeout
U0151SRS-ABG CAN timeout
U0154OCM CAN timeout
U0168WCM/F.A.S.T. CAN timeout
U1000OSS/F.A.S.T._OSS CAN timeout
U1110A/C CAN timeout/Not equipped
U1190No receive fault detect signal
U1195Coding not completed