[Previous][Next]
REGISTRATION WHEN REPLACING KOS&OSS-ECU
 
 
caution
  • When KOS&OSS-ECU is replaced, all the registrations that need to be performed at KOS&OSS-ECU replacement must be completed before the registration of KOS&OSS-ECU.
  • Be sure to check that DTC B1157 EEPROM fail is not set. If DTC B1157 "EEPROM fail" is set, the VIN cannot be stored in memory even when it is written. Therefore, when this DTC is set, be sure to carry out the troubleshooting first to repair the trouble, and then write the VIN to KOS&OSS-ECU.
Required Special Tools:
  • MB992744: Vehicle communication interface-Lite (V.C.I.-Lite)
  • MB992745: V.C.I.-Lite main harness A (for vehicles with CAN communication)
  • MB992747: V.C.I.-Lite USB cable short
  • MB992748: V.C.I.-Lite USB cable long
  • MB991958 Scan Tool (M.U.T.-III Sub Assembly)
    • MB991824: Vehicle Communication Interface (V.C.I.)
    • MB991827 M.U.T.-III USB Cable
    • MB991910 M.U.T.-III Main Harness A
When KOS&OSS-ECU is replaced, the VIN needs to be registered to the replaced ECU.
 
 
 
 
VIN REGISTRATION PROCEDURE
1. Replace the KOS&OSS-ECU.
2.
caution
To prevent damage to scan tool (M.U.T-III), always turn the power supply mode of the engine switch to the OFF position before connecting or disconnecting scan tool (M.U.T-III).
Connect scan tool (M.U.T-III) to the data link connector.
3. From the system selection screen of scan tool (M.U.T-III), select "F.A.S.T./OSS/IMMO/Keykess/TPMS".
4. From the F.A.S.T./OSS/IMMO/Keykess/TPMS function menu screen, select "Coding".
5.
From the coding menu screen, select "Chassis No./VIN Writing."
6.
Following the instruction on the screen, press the "OK" button to execute the VIN writing. (scan tool (M.U.T-III) screen above indicates when KOS&OSS-ECU is replaced.)
7.
On the writing result confirmation screen, check that the VIN is written, and finish the registration.
8. Operate the engine switch to turn "OFF" the power supply.
noteAfter the scan tool (M.U.T-III) has executed the VIN writing, it will turn the engine switch on forcibly. Therefore, after completion, turn the engine switch off.
9. Set the driver's door from open to close or from close to open.
10. Carrying the keyless operation key, perform the engine switch operation to turn the power from "OFF" to "ON" twice.
11. Check that the KOS&OSS-ECU DTC (B1160, B1166 or U1199) is not set, and finish the registration.