[Previous][Next]
DTC B2352: Antenna fail
 
 
cautionWhen replacing the ECU, always check that the communication circuit is normal.
 
 
DTC SET CONDITION
If an open circuit or short to ground occurs in the key slot, KOS&OSS-ECU stores DTC B2352.
 
 
TECHNICAL DESCRIPTION (COMMENT)
When the key slot and the KOS&OSS-ECU are communicating, the KOS&OSS-ECU will send a signal to the key slot. Then the key slot will send a code to the keyless operation key via its antenna. If the KOS&OSS-ECU detects open circuit or short circuit to ground consecutively four times during the operation above, the ECU will store this diagnostic trouble code.
 
 
TROUBLESHOOTING HINTS
  • Malfunction of the key slot
  • Damaged wiring harness and connectors
  • Malfunction of KOS&OSS-ECU
 
 
DIAGNOSIS
STEP 1. Key slot check.
Check that the key slot is normal (Refer to ).
Is the key slot normal?
Go to Step 2.
Replace the key slot
 
STEP 2. Check of short to power supply, short to ground, and open circuit in ANTP, ANTG line between the key slot connector and the KOS&OSS-ECU connector.
Is the check result normal?
Go to Step 3.
Repair the wiring harness.
 
STEP 3. Recheck for diagnostic trouble code.
Check again if the DTC is set in the KOS&OSS-ECU.
(1) Open the driver's door.
(2) Erase the DTC.
(3) Turn the power supply mode of the engine switch from OFF to ON.
(4) Check if DTC is set.
(5) Turn the power supply mode of the engine switch to OFF.
Is the DTC set?
Replace KOS&OSS-ECU and register the ID codes (Refer to ).
The diagnosis is complete.