[Previous][Next]
Inspection Procedure 4: Keyless operation warning display does not disappear
 
 
cautionBefore replacing the ECU, ensure that the power supply circuit, the ground circuit and the communication circuit are normal.
 
 
 
 
TROUBLESHOOTING HINTS
  • Malfunction of CAN bus line
  • Malfunction of combination meter
  • Malfunction of the KOS&OSS-ECU
 
 
 
DIAGNOSIS
STEP 1. Using scan tool (M.U.T.-III), diagnose the CAN bus line.
(1)
cautionTo prevent damage to scan tool (M.U.T.-III), always turn the power supply mode of the engine switch to the "OFF" position before connecting or disconnecting scan tool (M.U.T.-III).
Connect scan tool (M.U.T.-III) [Refer to "How to connect scan tool (M.U.T.-III) "].
(2) Turn the power supply mode of the engine switch to "ON".
(3) Diagnose the CAN bus line.
(4) Turn the power supply mode of the engine switch to "OFF".
Is the CAN bus line found to be normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C, Diagnosis ).
 
STEP 2. Using scan tool (M.U.T.-III), read the other system diagnostic trouble code.
Check if any DTC is set in the combination meter.
(1)
cautionTo prevent damage to scan tool (M.U.T.-III), always turn the power supply mode of the engine switch to the "OFF" position before connecting or disconnecting scan tool (M.U.T.-III).
Connect scan tool (M.U.T.-III) [Refer to "How to connect scan tool (M.U.T.-III) "].
(2) Turn the power supply mode of the engine switch to "ON".
(3) Check if DTC is set.
(4) Turn the power supply mode of the engine switch to "OFF".
Is the DTC set?
Perform troubleshooting for the combination meter (Refer to GROUP 54A, Combination Meter - Troubleshooting ).
Go to Step 3.
 
STEP 3. Using scan tool (M.U.T.-III), read the diagnostic trouble code.
Check if any DTC is set in the KOS&OSS-ECU.
(1)
cautionTo prevent damage to scan tool (M.U.T.-III), always turn the power supply mode of the engine switch to the "OFF" position before connecting or disconnecting scan tool (M.U.T.-III).
Connect scan tool (M.U.T.-III) [Refer to "How to connect scan tool (M.U.T.-III) "]
(2) Turn the power supply mode of the engine switch to "ON".
(3) Check if DTC is set.
(4) Turn the power supply mode of the engine switch to "OFF".
Is the DTC set?
Refer to diagnostic trouble code chart .
Go to Step 4.
 
STEP 4. Retest the system.
Check that the keyless operation warning light turns "OFF" unless the flashing or illumination conditions are met.
Is the check result normal?
Intermittent malfunction is suspected (Refer to GROUP 00, How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).
Replace KOS&OSS-ECU and register the ID codes (Refer to ).