[Previous][Next]
DISASSEMBLY AND REASSEMBLY
 
 
warningCertain components of this vehicle, such as coin-type lithium battery may contain perchlorate materials. Before deployment and/or disposal of these components, review and comply with all applicable Federal, state and local regulations.
Post-installation operation
Operation check of the keyless operation key
Disassembly steps
<<A>>1.Emergency key
<<B>>2.Upper cover
<<B>>3.Transmitter assembly
<<B>>>>A<<4.Battery
<<B>>5.Lower cover
 
 
DISASSEMBLY SERVICE POINTS
 
 
<<A>> EMERGENCY KEY REMOVAL
Move the lever on the lower cover to the direction shown by the arrow to remove the emergency key from the keyless operation key.
 
 
 
<<B>> UPPER COVER/TRANSMITTER ASSEMBLY/BATTERY/LOWER COVER REMOVAL
cautionDo not allow water or dust to enter the inside of the transmitter assembly when it is open. Also, do not touch the precision electronic device.
Set a flat-tipped screwdriver wrapped with protective tape as shown in the figure, and pry off the keyless operation key.
 
 
 
 
REASSEMBLY SERVICE POINT
 
 
>>A<< BATTERY INSTALLATION
cautionDo not allow water or dust to enter the inside of the transmitter assembly when it is open. Also, do not touch the precision electronic device.
Install a battery with the positive side facing toward the lower cover.
Replacement battery: Coin-type lithium battery CR2032