The vehicle speed detection encoder collects any metallic particle easily, because it is magnetized. Make sure that the encoder should not collect any metallic particle. Check that there is not any trouble prior to reassembling it.
The wiring harness for the wheel speed sensor should be routed without twisting.
Pre-removal and post-installation operation
Rear Scuff Plate Removal (Refer to GROUP 52A, Interior Trim ) <Rear wheel speed sensor>
Front wheel speed sensor removal steps
1.
Bolt (front wheel speed sensor and knuckle connection)
2.
Front wheel speed sensor connector
3.
Sensor bracket
4.
Front wheel speed sensor
Rear wheel speed sensor removal steps
5.
Bolt (rear wheel speed sensor and trailing arm assembly connection)
6.
Rear wheel speed sensor connector
>>A<<
7.
Rear wheel speed sensor
note
The encoder for detecting front wheel speed is a non-disassemble part integrated with the wheel bearing.
INSTALLATION SERVICE POINTS
>>A<< REAR WHEEL SPEED SENSOR INSTALLATION
Install the rear wheel speed sensor grommet to the rear floor panel snugly as shown in the figure.
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
)
)
