[Previous][Next]
STOPLIGHT SWITCH CHECK
 
 
 
 
<M/T (Without cruise control)>
cautionDo not apply grease or lubricant to the switch and the switch installation section to avoid malfunction of the switch. In addition, do not use gloves which have grease on them.
Check for continuity between the terminals of the switch.
 
Check conditionTerminal connector of testerNormal condition
At free position1 - 2Continuity exists
(2 Ω or less)
Press the plunger from the edge of the outer case by the dimension shown in the figure1 - 2No continuity
 
 
 
<CVT, M/T (With cruise control)>
cautionDo not apply grease or lubricant to the switch and the switch installation section to avoid malfunction of the switch. In addition, do not use gloves which have grease on them.
Check for continuity between the terminals of the switch.
 
Check conditionTerminal connector of testerNormal condition
At free position1 - 2 (for stoplight switch)Continuity exists
(2 Ω or less)
3 - 4 (for cruise control)No continuity
Press the plunger from the edge of the outer case by the dimension shown in the figure.1 - 2 (for stoplight switch)No continuity
3 - 4 (for cruise control)Continuity exists
(2 Ω or less)