[Previous][Next]
DISASSEMBLY AND REASSEMBLY
 
 
Disassembly steps
1.Snap ring
<<A>>2.Wheel bearing
3.Hub bolt
4.Hub
Assembly steps
4.Hub
3.Hub bolt
>>A<<2.Wheel bearing
1.Snap ring
>>B<<•Wheel bearing rotary-sliding resistance check
>>C<<•Wheel bearing end play check
Required Special Tools:
  • MB991152: Dust cover installer
  • MB991389: Bush removal base
  • MD998717: Oil seal installer
  • MB991576: Base
 
 
DISASSEMBLY SERVICE POINTS
 
 
<<A>> WHEEL BEARING REMOVAL
Use the following special tools to remove the wheel bearing.
  • Dust cover installer (MB991152)
  • Bush removal base (MB991389)
 

 
 
 
ASSEMBLY SERVICE POINT
 
 
>>A<< WHEEL BEARING INSTALLATION
1. Install the wheel bearing so that the sealed section with the silver metal sheet faces inside of the vehicle and the black rubber side faces outside of the vehicle.
2. Use the following special tools to press-fit the wheel bearing:
  • Oil seal installer (MD998717)
  • Base (MB991576)
 

 
 
>>B<< WHEEL BEARING ROTARY-SLIDING RESISTANCE CHECK
Refer to .
 

 
 
>>C<< WHEEL BEARING END PLAY CHECK
Refer to .