23A-SELECTOR LEVER ASSEMBLY CONTINUITY CHECK

SELECTOR LEVER ASSEMBLY CONTINUITY CHECK

SWITCH CHECK

Item	Transmission range	Terminal number	Continuity
P position detect switch <Vehicles with KOS>	P	4 - 6	Open loop
P position detect switch <Vehicles with KOS>	Other than above	4 - 6	Should be less than 2 ohm
P position detect switch <Vehicles without KOS>	P	5 - 6	Open loop
P position detect switch <Vehicles without KOS>	Other than above	5 - 6	Should be less than 2 ohm
Ds position switch	Ds, L	8 - 9	Should be less than 2 ohm
Ds position switch	Other than above	8 - 9	Open loop

KEY LOCK RELAY CHECK <VEHICLES WITHOUT KOS>

1. Shift the selector lever to "P" position.

2. Use a jumper wire to connect terminal number 5 of the selector lever assembly connector to the positive battery terminal, terminal number 6 to the negative battery terminal. Then apply battery voltage.

3. Check for continuity between the selector lever assembly connector terminals number 4 and number 5.

Jumper wire	Continuity between terminals number 4 and number 5
Connect	Yes (Should be less than 2 ohm)
Disconnect	No