>>A<< CRANKSHAFT PULLEY/CRANKSHAFT PULLEY WASHER/CRANKSHAFT PULLEY CENTER BOLT INSTALLATION
1. Using a rag, wipe dirt on the crankshaft thread hole and the crankshaft pulley washer.
2. Using a rag, wipe dirt on the crankshaft pulley and then degrease the place specified in the illustration.| note | Perform degreasing to prevent the friction resistance from decreasing in the compressed area due to the residual oil. |
3. Install the crankshaft pulley.
4. Apply the minimum amount of engine oil to the crankshaft bolt threads and the seating surface.
5. Use the following special tools as during removal to support the crankshaft pulley.- Front hub and flange yoke holder (MB990767)
- Pin (MD998719)
6. Tighten the crankshaft pulley center bolt to the specified torque.Tightening torque: 50 N·m (37 ft-lb)
7. As shown in figure A, put a paint mark on one angle of the crankshaft pulley center bolt. Then, put a paint mark on the crankshaft pulley on the extended line of the angle next to the marked angle.
8. | caution | - When the tightening angle is smaller than the specified tightening angle, the appropriate tightening capacity cannot be secured.
- When the tightening angle is larger than the specified tightening angle, remove the bolt to start from the beginning again according to the procedure.
|
Tighten the crankshaft pulley center bolt in a 60°, and check that the paint mark on the crankshaft pulley center bolt aligns with the paint mark on the crankshaft pulley as shown in figure B.
9. Loosen the crankshaft pulley center bolt completely after steps 6 to 8, and then repeat steps 6 to 8.
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
)
)
)
)
)
)
)
)
)
