[Previous][Next]
Inspection Procedure 3: The key reminder switch signal is not received.
 
 
cautionWhenever the ECU is replaced, ensure that the power supply circuit, the ground circuit and the communication circuit are normal.
 
 
TECHNICAL DESCRIPTION (COMMENT)
Input signal from the key reminder switch is used to operate the functions below. If the signal is abnormal, these functions will not work normally.
  • Ignition key reminder tone alarm function
  • Central door locking
  • Keyless entry system
  • Dome light
 
 
TROUBLESHOOTING HINTS
  • The key reminder switch may be defective
  • The ETACS-ECU may be defective
  • The wiring harness or connectors may have loose, corroded, or damaged terminals, or terminals pushed back in the connector
 
 
DIAGNOSIS
Required Special Tools:
  • MB992006: Extra fine probe
  • MB991223: Harness set
STEP 1. Check the key reminder switch.
Refer to .
Is the check result normal?
Go to Step 2.
Replace the key reminder switch.
 
STEP 2. Resistance measurement at key reminder switch connector (ground terminal)
(1) Disconnect the connector, and measure at the wiring harness side.
(2) Measure the resistance between the key reminder switch connector (ground terminal) and ground.
OK: The resistance should be 2 ohms or less
Is the check result normal?
Go to Step 4.
Go to Step 3.
 
STEP 3. Check of open circuit in ground line between key reminder switch connector and the ground
Is the check result normal?
Intermittent malfunction is suspected (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).
Repair the connector(s) or wiring harness.
 
STEP 4. Check of short to power supply, short to ground, and open circuit in HL1+ line between ETACS-ECU connector and key reminder switch connector
Is the check result normal?
Go to Step 5.
Repair the connector(s) or wiring harness.
 
STEP 5. Using scan tool (M.U.T.-III), check data list.
(1)
cautionTo prevent damage to scan tool (M.U.T.-III), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-III).
Connect scan tool (M.U.T.-III). Refer to "How to connect Scan Tool (M.U.T.-III) ."
(2) Check the input signals from the key reminder switch.
  • Ignition switch: "LOCK" (OFF) (key inserted)
 
Item No.Item nameNormal condition
28Steering lock switchOFF
OK: Normal condition is displayed.
Is the check result normal?
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction ).
Replace the ETACS-ECU.