[Previous][Next]
INSPECTION
 
 
 
 
SEAT BELT SWITCH CONTINUITY CHECK (DRIVER’S SIDE)
ItemTester connectionSpecified condition
Fastened seat belt1 - 2Open circuit
Unfastened seat belt1 - 2Continuity exists (2 ohms or less)
Power supply voltage: 5 V
Power supply connectionCheck conditionNormal condition
  • Connect terminal number 4 to the negative power supply (5 V) terminal.
  • Connect terminal number 3 to the positive power supply (5 V) terminal.
When the seat belt is connected12 - 17 mA
When the seat belt is disconnected4 - 7 mA
 
 
 
SEAT BELT SWITCH CONTINUITY CHECK (PASSENGER’S SIDE)
If there is no continuity when the outer seatbelt is fastened, replace the inner seatbelt.
 
ItemTester connectionSpecified condition
Fastened seat belt1 - 2Open circuit
Unfastened seat beltContinuity exists (2 ohms or less)