[Previous][Next]
REMOVAL AND INSTALLATION
 
 
cautionBefore removing the front seat assembly, refer to GROUP 52B, Service Precautions and Air Bag Module and Clock Spring .
Removal steps
1.Headrestraint
<<A>>•Wiring harness connectors
>>A<<2.Front seat assembly
 
 
REMOVAL SERVICE POINT
 
 
<<A>> WIRING HARNESS CONNECTORS DISCONNECTION
Disconnect the following wiring harness connectors:
Connector numberConnector name
D-25
(2 - yellow)		Side air bag module (squib) connector (LH)
D-27
(2 - yellow)		Side air bag module (squib) connector (RH)
D-26 (2)Front seat belt switch connector (Driver’s side)
D-35 (2)Front seat belt switch connector (Passenger’s side)
D-30 (4)Heated seat connector (LH) <Vehicle with heated seat>
D-31 (4)Heated seat connector (RH) <Vehicle with heated seat>
noteWhen disconnecting the side air bag module connectors of D-25 and D-27, unlock the connector by sliding the locking button to the direction of the arrow as shown in the figure, and then disconnect the connector.
 
 
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< FRONT SEAT ASSEMBLY INSTALLATION
1. Confirm that both the seat slides are locked, and then temporarily tighten all the bolts and nuts shown in the figure so that no load is applied to the front seat cushion.
2. Tighten all the bolts and nuts to the specified torque.
Tightening torque: 43 ± 8 N·m (32 ± 5 ft-lb·) (Bolt)
Tightening torque: 30 ± 5 N·m (22 ± 3 ft-lb·) (Nuts)