[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Door mirror assembly removal steps
•Front door delta inner cover (Refer to GROUP 52A, Door Trim )
<<A>>•Door mirror connector connection
1.Door mirror assembly
Door mirror outer cover removal steps
<<B>>2.Mirror
<<C>>>>A<<3.Door mirror outer cover
Remote controlled mirror switch removal steps
•Instrument panel under cover (Refer to group 52A, Instrument panel assembly .)
4.Remote controlled mirror switch
 
 
REMOVAL SERVICE POINTS
 
 
<<A>> DOOR MIRROR CONNECTOR CONNECTION REMOVAL
1. The door mirror can be removed and installed without removing the front door trim.
2. The front door delta inner cover must be removed to gain access to the door mirror connector as it is located inside the front door trim.
 
 
 
<<B>> MIRROR REMOVAL
cautionThe tab of the mirror is prone to breakage when working in cold temperatures. Always use a hair drier or the like to warm up the mirror tab and its periphery to 20°C (68°F) or higher prior to works. When the mirror is heated too quickly from its cold state, it may be broken.
1. Slant the mirror upward with your hands. Then insert a flat-tipped screwdriver wrapped with protective tape between the pivot plate and mirror through the cut-out from behind the mirror. Now pry off the mirror tab and release the lower side of the mirror as shown in the illustration.
2. Release the upper side of the mirror from the tab as shown while pulling out the mirror.
 

 
 
<<C>> DOOR MIRROR OUTER COVER REMOVAL
Remove the door mirror outer cover by disengaging the claws in the numerical order of the illustration from the mirror body side.
 
 
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< DOOR MIRROR OUTER COVER INSTALLATION
cautionTap the claw positions securely to confirm that they are engaged securely.
Install the door mirror outer cover by engaging the claws in the numerical order of the illustration.