[Previous][Next]
DTC B2416: ECU internal error
 
 
 
 
DTC SET CONDITION
KOS-ECU stores DTC B2416 when it determines itself to be in abnormal status.
 
 
TECHNICAL DESCRIPTION (COMMENT)
KOS-ECU determines that the abnormality is present, if the data abnormality is found when the ignition switch is turned ON and then EEPROM is written.
 
 
TROUBLESHOOTING HINTS
Malfunction of KOS-ECU
 
 
DIAGNOSIS
Recheck for diagnostic trouble code.
Check again if the DTC is stored in the KOS-ECU.
(1)
cautionTo prevent damage to scan tool (M.U.T-III), always turn the power supply mode of the engine switch to the OFF position before connecting or disconnecting scan tool (M.U.T-III).
Connect scan tool (M.U.T-III). Refer to "How to connect scan tool (M.U.T.-III) ."
(2) Erase the DTC.
(3) Turn the power supply mode of the engine switch to ON.
(4) Check if DTC is stored.
(5) Turn the power supply mode of the engine switch to OFF.
Is the DTC stored?
Replace KOS-ECU and register the ID codes (Refer to ).
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction ).