[Previous][Next]
DTC B240A: DR side antenna(outdoor) open
 
 
cautionWhen replacing the ECU, always check that the communication circuit is normal.
 
 
DTC SET CONDITION
If an open circuit is detected in the outside transmission antenna (driver's side), the DTC is stored.
 
 
TECHNICAL DESCRIPTION (COMMENT)
When the engine switch is pressed, or when the antenna open circuit detection request is received from the diagnosis function, the failure is detected.
 
 
TROUBLESHOOTING HINTS
  • Malfunction of the outside transmission antenna assembly (driver's side)
  • Malfunction of the KOS-ECU
  • Damaged wiring harness and connectors
 
 
DIAGNOSIS
STEP 1. Check of short to power supply, short to ground, and open circuit in EDRP, EDRG line between the outside transmission antenna assembly (driver's side) connector and the KOS-ECU connector.
Is the check result normal?
Go to Step 2.
Repair the connector(s) or wiring harness.
 
STEP 2. Keyless operation system communication test
Check that the communication with the outside transmission antenna assembly (driver's side) is normal (Refer to Antenna Test ).
Antennas to be checked
  • Driver side antenna (exterior)
OK: Normal is displayed.
Is the check result normal?
Go to Step 3.
Replace the outside transmission antenna assembly (driver's side).
 
STEP 3. Check whether the diagnosis trouble code is stored again.
(1) Erase the DTC.
(2) Turn the power supply mode of the engine switch from OFF to ON.
(3) Check if the DTC is stored.
(4) Turn the power supply mode of the engine switch from ON to OFF.
Is the DTC stored?
Replace KOS-ECU and register the ID codes (Refer to ).
Intermittent malfunction is suspected (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Deal with Intermittent Malfunction ).