[Previous][Next]
DTC B1A10: Keyless/KOS key 1 low battery
DTC B1A11: Keyless/KOS key 2 low battery
DTC B1A12: Keyless/KOS key 3 low battery
DTC B1A13: Keyless/KOS key 4 low battery
 
 
cautionWhen replacing the ECU, always check that the communication circuit is normal.
 
 
DTC SET CONDITION
If KOS-ECU receives the keyless operation key low battery voltage signal, KOS-ECU stores DTC No. B1A10, B1A11, B1A12, or B1A13.
 
 
TECHNICAL DESCRIPTION (COMMENT)
  • B1A10: If KOS-ECU receives the keyless operation key 1 (the first keyless operation key registered with KOS-ECU) low battery voltage signal in five consecutive times, it is judged as abnormal.
  • B1A11: If KOS-ECU receives the keyless operation key 2 (the second keyless operation key registered with KOS-ECU) low battery voltage signal in five consecutive times, it is judged as abnormal.
  • B1A12: If KOS-ECU receives the keyless operation key 3 (the third keyless operation key registered with KOS-ECU) low battery voltage signal in five consecutive times, it is judged as abnormal.
  • B1A13: If KOS-ECU receives the keyless operation key 4 (the fourth keyless operation key registered with KOS-ECU) low battery voltage signal in five consecutive times, it is judged as abnormal.
 
 
TROUBLESHOOTING HINTS
  • Malfunction of the keyless operation key battery
  • Malfunction of the keyless operation key
  • Malfunction of KOS-ECU
 
 
DIAGNOSIS
STEP 1. Replace the battery in the keyless operation key and recheck the diagnostic trouble code.
Replace the battery of the keyless operation key for which the DTC is stored, and check whether the DTC is stored again.
(1) Replace the battery of the keyless operation key for which the DTC is stored.
(2) Erase the DTC.
(3) Turn the power supply mode of the engine switch from OFF to ON.
(4) Lock or unlock the keyless operation key.
(5) Check if the DTC is stored.
Is the DTC stored?
Go to Step 2.
The diagnosis is complete (Discharged battery).
 
STEP 2. Replace the keyless operation key and recheck the diagnostic trouble code.
Replace the keyless operation key for which the DTC is stored with a new one, register the key ID and keyless operation key ID (refer to ), and check whether the DTC is stored again.
(1) Erase the DTC.
(2) Turn the power supply mode of the engine switch from OFF to ON.
(3) Check if the DTC is stored.
Is the DTC stored?
Replace KOS-ECU and register the ID codes (Refer to ).
The diagnosis is complete.