42A-POWER WINDOW INITIALIZED ADJUSTMENT<Vehicles with safety system (driver side)>

LEARNING PROCEDURES OF POWER WINDOW FULLY CLOSED POSITION <Vehicles with safety system (driver’s side door)>

LEARNING PROCEDURES OF FULLY CLOSED POSITION WHEN POWER WINDOW SWITCH IS REMOVED, OR POWER WINDOW REGULATOR ASSEMBLY IS REMOVED OR REPLACED

1. If the battery terminals are disconnected or the fuse for power window is removed, the fully closed position that the power window switch has learned will be erased (initialized).

2. Operate the power window switch and fully open the door window glass.

caution

The anti-trap function will not activated until the learning procedures of the fully closed position have been completed (because the anti-trap function was reset).

Operate the power window switch and fully close the door window glass. Release the power window switch once. Then, hold the power window switch to the fully closed side again for 1 second so that the power window switch completes learning the fully closed position.

note	If the power window switch is operated to open the door window glass while the switch is in learning procedure, the learning will be cancelled. If this happens, return to Step 2.

LEARNING PROCEDURES WHEN POWER WINDOW SWITCH IS REPLACED WITH A NEW ONE

caution

The anti-trap function will not activated until the learning procedures of the fully closed position have been completed (because the anti-trap function was reset).

Operate the power window switch to fully close the door window glass by one-shot up action so that the power window switch will complete learning (no initialization is required).